Puffco Peak Pro 3D Chamber

Puffco Peak Pro 3D Atomizer

The Puffco 3D Chamber is an upgrade over the stock atomizer thanks to the embedded heat sensors and coils running throughout the side walls of the chamber. This leads to more even heating of your dabs without any hot or cold spots. The result is more consistent and smoother hits with better flavor as well. Pair it with the Puffco Hot Knife for even more optimal performance.

How to use the Puffco Peak Pro 3D Chamber?

Downloading the Puffco App is required for full functionality of the 3D chamber, and this chamber is only compatible with the Puffco Peak Pro. Simply swap it in place of the normal atomizer, and make sure you are connected to the app via Bluetooth.

From there go to settings and click firmware update and install it while your 3D chamber is threaded onto the Peak Pro and the battery is above 60% charge.

Once it’s ready, your Peak Pro’s firmware setting will say ‘Device up to date’.

Puffco Peak Pro 3D Chamber Maintenance

For regular cleaning of a Puffco 3D chamber, you can use vape cleaning sticks a few minutes after your session after it has cooled down enough to not be hot. For a more thorough cleaning of the Peak Pro 3D Chamber, you can unthread it and soak it in 99% isopropyl alcohol for at least twenty minutes to loosen up any chazzed or burnt dabs.

3D Chamber not being recognized?

If your 3D chamber isn’t being recognized, here are some troubleshooting steps to get your chamber to work:

• Try cleaning the metallic connections on the bottom of the atomizer and on your Puffco Peak Pro
• Try twisting it slightly back and forth to make sure that it’s fully dropped into the slot
• Make sure you are up to date with the newest Puffco Peak Pro App
• Twenty clicks of the power button will reset your Puffco Peak Pro back to factory settings

What's in the box

x1 Puffco Peak Pro 3D Chamber